Selling Price -
$48,275.00
2024 John Deere 2 Series 2025R
- Powerful and fuel-efficient Tier IV Yanmar engine
- Hydro transmission with TwinTouch™ pedals for ease of use
- AutoConnect™ 7-Iron Drive-over mower decks up to 60 inches
Features may include:
Durable, efficient, high-torque 3-cylinder diesel engine provides adequate power- Power is provided by a durable and efficient high-torque three-cylinder Yanmar® TNV Series diesel engine.
- This series of engines was developed to meet Tier 4 Environmental Protection Agency (EPA) environmental requirements by featuring low levels of both exhaust and emissions.
- YANMAR TNV SERIES ENGINE OFFERS THESE FEATURES:
- Economical for good cooling and long life
- Isolated engine provides reduced vibration and noise for the operator; indirect fuel injection uses a precombustion chamber to give the engine a smooth and quiet operation; aluminum-alloy piston with built-in steel struts are lightweight to reduce connection rod bearing loads and provide good heat transfer characteristics
- Design permits tighter tolerances and neutralizes expansion of the piston, thereby reducing blow-by gas and less noise from the piston slap
- Higher top rings on the piston and a thinner head gasket greatly reduces the volume of unburned waste gases and increases combustion efficiency
- Timing-gear teeth have a designed roll-off profile giving almost no clash, no noise, and no backlash
- High-torque reserve provides plenty of power under heavy load, yet retains excellent fuel economy
- Easy access to engine check and fill points on the right-hand side of the tractor by removing the side panels
- Fuel filter with replaceable element
- Full-pressure lubrication system provides filtered oil under pressure to all vital engine parts
- Glow plugs provide quick starts in temperatures down to -18°C (0°F)
- Auto-bleed fuel system means there is no special bleeding required if the tractor runs out of fuel; this system will self-prime the injection pump, lines, and injectors, providing fast fuel recovery
- Key start and shut off eliminates fuel shut-off knob
- Electric solenoid shuts fuel supply off immediately when key is turned off
- See-through coolant recovery tank permits operator to check coolant level without removing radiator cap
- Dry-type air cleaner with safety element keeps dirt and other contaminants out of the engine
- Safety element (second filter) will protect engine if primary filter would develop a leak
- Protects engine when servicing primary filter
- Air filter restriction indicator is standard equipment on the 2025R Tractor
- Sealed-radiator compartment keeps trash and debris on outside of hood
- Horizontal exhaust discharges fumes away from the operator station, reducing noise and improving operator visibility and comfort
- Yanmar is a trademark of Yanmar Company Limited.
- The 2R Series are equipped with a two-range hydrostatic transmission (HST) incorporated in a die-cast aluminum transmission case. Fluid under pressure transmits engine power to the drive wheels via a closed-loop pump and motor arrangement. Infinite ground speeds allow the operator to match the speed of the tractor to the job.
- 2024
- John Deere
- 2 Series
- 2025R
- Compact
- Model: 3TNV80F-NCJT
- SAE J1995 rated power: 17.8 kW (23.9 hp) / 24.2 PS at 3200 rpm
- Yanmar®
- 3200 rpm
- Natural
- Final Tier 4
- 1.267 L (77 cu in.)
- Three | Cast-in-block
- 80 mm (3.2 in)
- 84 mm (3.3 in.)
- Pressurized
- Water pump
- Dual element
- At rated speed: 53.1 Nm (39.1 lb-ft)
- Power take-off (PTO) power: 12.8 kW (17.2 hp) | Rear - 540 rpm / Mid - 2100 rpm
- Indirect injection
- Diesel
- 23.1:01
- Indirect injection
- Hydrostatic - two range
- Spur gear
- Power steering
- Wet disk
- Wet disk
- R3 Turf: 23x8.50-12 / R3 Radial: 220/55-R12 / R4 Industrial: 23x8.50-12
- R3 Turf: 12-16.5 / R3 Radial: 280/70 R16 / R4 Industrial: 12-16.5
- 500 CCA
- 40 amp
- Starter size: 1.2 kW (1.6 hp)
- Open center | Remote control valves available: Two
- Steering: 13.4 L/min (3.5 gpm) / 13.25 L/min (3.5 gpm) | Implement: 13.4 L/min (3.5 gpm) / 13.25 L/min (3.5 gpm) / 26.5 L/min (7.0 gpm)
- Gear
- 137 bar (1987 psi)
- Limited Category 1
- 1600 mm (63 in.)
- Without brakes: 2.51 m (8.2 ft)
- 20.4 L (5.39 gal.)
- 612 kg (1349 lb)
- 1100 kg (2425 lb)
- 24-in. behind link arms: 415 kg (915 lb)
- Draft control sensing: Position control | Control: Independent | Platform - flat/straddle: Three-piece semi flat | Gear shift location - console/floor: Left-hand side
- Open station: 849 kg (1872 lb) / Cab: 1085 kg (2392 lb)
- 4WD
- $48,275.00
- On Order
- New
- On Order
- 2024
- John Deere
- 2 Series 2025R
- 3 Cylinder Diesel Engine
- 25 HP
- Hydrostatic - two range
- Diesel
- Available
- 4WD